home> USER GUIDE > Basic Knowledge> Dynamic Residential Proxy Extraction Tutorial

Dynamic Residential Proxy Extraction Tutorial

API extraction

Note: You need to add your local IP to the IP whitelist before using the API. Please refer to: [IP Whitelist Tutorial] 

1. Click API extraction and select Dynamic Residential Proxy

2. Select the IP extraction quantity, extraction country, protocol and other information

Note: IP modes are divided into sticky IP and rotating IP. Sticky IP is changed every five minutes. Rotating IP will change the IP every time a request is made.

3. Click Generate API link, choose to copy the link and use it directly, or open the link to view the IP list

Note: The IPs in the IP list are not the actual IPs used, so some of them are displayed the same. In actual use, different ports and IPs are different.

Account and password mode

1. Click Account Authentication and select Dynamic Residential proxy

2. Select the country and IP mode to be withdrawn. If you need a sub-account, you can select a sub-account or create a sub-account.

Note: IP mode rotates IP and sticky IP every minute. Rotating IP will change the IP every time it is requested. For sticky IP, you can select the IP stabilization time. For example, if you select five minutes, the IP will be changed every five minutes.

3. After the selection is completed, you can copy the test command and paste it into the command prompt for testing. As shown in the figure, the test result is that the proxy is normal and you can use it.

If the test result shows that the connection cannot be made, please send the test command and test results to the official email: [email protected]

We will arrange technicians to detect and repair it for you

4. If you need to extract proxy by city and continent, you can view the setting tutorial case on the right side of the account authentication page, click on the city code and continent list to view the codes corresponding to the city and continent, and set it according to the use case

Configuration tutorial—taking Bit Browser as an example

1. First open Bit Browser and click Browser Configuration - Add

2.1 API extraction

Open the API link, enter the IP port in the IP list into the corresponding location, select the protocol you need, and click Detect proxy. After the detection is successful, click Confirm to use it.

2.2 Account and password mode

Fill in the host and port, account number, and password of the account authentication interface into the corresponding positions, click Detect proxy, and click Confirm after the detection is successful.

Note: Account mode only supports socks5 protocol, and the account password must be filled in before it can be used.

If the detection fails, please refer to the tutorial: [Proxy cannot connect] for testing